Skip to content
EQPS

Equipment and SystemsLesson 5 of 6

EQPS 005

Other surveillance systems

The three at a glance

The three systems of this lesson side by side; each name opens its section.

ADS-B, ADS-C and MLAT side by side
ADS-BADS-CMLAT
Who works out the positionThe aircraft, by GNSSThe aircraft, by GNSSThe ground, from the time differences: TDOA
How the data travelsBroadcast: sent out to all who can receive itUnder a contract, over ACARSTransponder signals, on 1090 MHz
Who receives itGround stations, for ATC; other aircraft, with ADS-B InThe service provider's ground systemReceivers on the ground, time-synchronised
Where it is usedNon-radar areas, radar areas and airportsWhere radar coverage is not achievable: transcontinental and oceanic areasLAM: airport ground surveillance and the vicinity of the aerodrome
WAM: en route
Dependent or independentDependentDependentIndependent
Cooperative or notCooperativeCooperativeCooperative
ADS

ADS

ADS, automatic dependent surveillance: the aircraft works out its own position and sends it. On the two pairs of EQPS 001, ADS is dependent and cooperative.

The two pairs
CooperativeNon-cooperativeDependentIndependentADS
DependentOn the aircraft's systems: the aircraft works out its own position, by GNSS, the global navigation satellite system.
CooperativeThe aircraft's equipment takes part: it sends the position.

A GPS augmentation is a system that makes GPS, the global positioning system, more accurate and reliable.

GNSS and EGNOS
GNSSGPSGalileoThe aircraft works outits own positionEGNOSImproves GPS
GalileoThe EU's own satellite navigation system: a GNSS, like GPS.
EGNOSThe European Geostationary Navigation Overlay Service: the EU's augmentation system. Today it improves GPS; later Galileo too.
Two kinds of ADS
ADS-BBroadcastSent out to all who can receive it: ground stations and other aircraft.
vs
ADS-CContractSent to the service provider's ground system, under a contract, over ACARS.

ADS-B

ADS-B, automatic dependent surveillance broadcast: the aircraft works out its position by GNSS and broadcasts it, with its other data, to all who can receive it.

How it works
GNSSUsed to work out the positionADS-B OutADS-B Out / InAircraft to aircraftOther aircraftwith ADS-B InADS-B OutVehicleGround stationReceiver, for ATCADS dataATC
Each broadcast goes to all who can receive it: a ground station on the ground, and other aircraft on board. Teal is what the aircraft and the vehicle send.
Out and In
ADS-B OutThe broadcastSent from an aircraft, or from a vehicle at the airport.
vs
ADS-B InReceiving it on boardAnother aircraft picks up the broadcast, to give its pilots a picture of the traffic around them.
It is
  • AutomaticNo action by the pilot.
  • DependentOn the aircraft's own systems for the data.
  • SurveillanceThe data is used for surveillance, in the air and on the ground.
  • BroadcastSent out to all who can receive it.
Where it is used
  • Non-radar areas
  • Radar areasWhere it enhances the radar.
  • Airports
It transmits
  • Aircraft identification
  • Position
  • Altitude
  • Speed
  • Accuracy and integrity performanceHow accurate the data is, and how far it can be trusted.

ADS-C

ADS-C, automatic dependent surveillance contract: an automatic position reporting system. The aircraft sends its position to the service provider's ground system, under a contract.

ADS-C
HOWOceanic: no radar coverageService provider'sground systemContractPosition reportsover the ACARS data linkWHEN: THREE CONTRACTSPosition reportPeriodic contractReports at regular timesOn-demand contractOne report, when the controller asksBy event contractA report after an event, such as a level change or a waypointRequestLevel changeWaypoint
The ground system sets up the contract, and the contract says when the aircraft reports: periodic, on demand or by event.
Where
  • Where radar coverage is not achievable
  • Transcontinental and oceanic areas
How
  • Data between the service provider and the aircraft
  • Over ACARSADS-C uses ACARS, the aircraft communication addressing and reporting system, as its data link (EQPS 003).
What
  • An automatic position reporting system
MLAT and the surveillance tree

MLAT

MLAT, multilateration: receivers on the ground pick up the signals the aircraft's transponder sends, and the ground works out the position from when each signal arrives.

Multilateration
1st2nd3rd4thTime-synchronisedPosition calculated on the groundTransponder: 1090 MHz1st2nd3rd4thTime differences: TDOATime
The signal reaches each receiver at a slightly different time. From those time differences, TDOA, the ground works out the position.
How it works
  • Receivers pick up transponder signalsOn 1090 MHz.
  • TDOATime difference of arrival.
  • 4 or more receivers3 are enough when the aircraft's pressure altitude is known.
  • Time-synchronisedAt many sites.
What kind
  • CooperativeEquipment on board is required: the transponder.
  • IndependentThe position is calculated on the ground.
  • It reads what the transponder sendsAll of it, such as the identity and the level.
Passive or active
  • PassiveIt only listens.
  • ActiveIt also interrogates the aircraft.
  • CheaperThan radar.

MLAT is cooperative and independent: the aircraft's transponder has to send, but the ground works out the position.

LAM and WAM

Two kinds of MLAT, by the area they cover.

Local or wide area
LAMLocal area MLATAirport ground surveillanceArrivalsDeparturesThe vicinity of the aerodromeWAMWide area MLATEn routeMLAT receiver
A-SMGCSAdvanced surface movement guidance and control system, at the airport (LAW 009). LAM is typically one of its parts, beside the surface movement radar (EQPS 004).

The surveillance tree

Every surveillance system on one tree, sorted by the two pairs of EQPS 001.

Surveillance
SurveillanceDependentThe aircraftIndependentThe groundCooperativeNon-cooperativeCooperativeADS-BADS-CPSRSSRSSR Mode SMLAT
Dependent surveillance is always cooperative: the aircraft has to send its position. PSR is the only non-cooperative one.

Reading material