Skip to content
NAV 010

Radio navigation, approach and landing procedures

The arrival

From en route to the runway

Three stages: the en-route segment, the arrival, and the approach.

En-route segmentFrom the end of the departure to the start of the arrival (NAV 009).
Arrival segmentFrom the en-route structure to the IAF, the initial approach fix, where the approach begins. Flown on a STAR, by vectoring, omnidirectionally (by the MSA or the TAA), or visually.
ApproachAn instrument approach, 3D or 2D, or a visual approach.

This lesson follows the same order: the arrival, the instrument approach and its kinds, then the minima and the approach chart.

The STAR

A STAR, standard instrument arrival, is a designated IFR arrival route (LAW 004). It links a point on the en-route structure to the point where the instrument approach begins.

A STAR's name
Basic indicatorThe point where the STAR begins: TELVO.
Validity indicatorA number from 1 to 9. It goes up each time the procedure changes: 2.
Route indicatorOne letter, never I or O: K.
SpokenWith the word ARRIVAL: TELVO TWO KILO ARRIVAL.
Other ways to arrive
VectoringATC gives the headings to fly, using an ATS surveillance system, in place of a published route.
OmnidirectionalFrom any direction, at or above the minimum altitude of the MSA or the TAA (next section).
VisualBy sight, with visual reference to the terrain, into a visual approach.

MSA and TAA

Two minimum altitudes for an aircraft arriving from any direction. Each keeps it at least 1 000 ft above everything within 25 NM.

MSA, minimum sector altitudeThe lowest altitude that gives at least 1 000 ft clearance above all objects in a sector of a circle of 25 NM round the aerodrome reference point (ARP) or a significant point.
Its centreThe ARP or a fix. The ARP: LAW 008.
TAA, terminal arrival altitudeThe lowest altitude with 1 000 ft clearance above all objects within 25 NM of an IAF (or of the IF, the intermediate fix, if there is no IAF), on a PBN approach. Together the TAAs cover 360° round the IF.

Where TAAs are published, they replace the MSA.

The instrument approach

Precision and non-precision

Instrument approaches are told apart by their guidance: lateral only, or lateral and vertical.

Instrument approach procedureA series of predetermined manoeuvres, flown by the instruments and protected from obstacles, from the IAF to a point where the aircraft can land. If it cannot land, the procedure goes on to a holding or the en-route structure.
2D, two-dimensionalLateral guidance only. Always a non-precision approach.
3D, three-dimensionalLateral and vertical guidance, on an APV or a PA procedure. An NPA flown with vertical guidance from the aircraft's own computer also counts as 3D.
NPANon-precision approachAPVApproach procedure with vertical guidancePAPrecision approach
Guidance2D: lateral only3D: lateral and vertical3D: lateral and vertical
Flown onLOC/DME, VOR/DME and NDB approaches, and RNP approaches flown to LNAV or LP minima.A PBN approach designed for 3D: RNP approaches flown to LNAV/VNAV or LPV minima.ILS, GLS, SBAS CAT I (an LPV flown to 200 ft) and MLS, which is rare. The only procedure for Type B operations, CAT I to III (below).
Three kinds of instrument approach procedure. Each approach named here has its own section below.

3D is not always precision. An APV gives vertical guidance too, but it is not a PA.

The approach segments

An instrument approach runs from fix to fix: IAF, IF, FAF or FAP, then the MAPt. Each segment begins at one fix and ends at the next.

IAF, initial approach fixWhere the initial approach segment begins.
IF, intermediate fixWhere the intermediate approach segment begins.
FAF, final approach fix, or FAP, final approach pointWhere the final approach segment begins: a FAF on a non-precision approach; a FAP on a precision approach, where the intermediate altitude meets the glide path.
MAPt, missed approach pointWhere the missed approach begins. On a non-precision approach the MAPt is a fix, a navigation aid or a distance. On a precision approach the missed approach starts at the DA/H, the decision altitude or height (below): the MAPt is where the glide path reaches it.

The approach in segments, from the FISO's side: PEN 004.

The initial approach

The initial approach segment begins at the IAF and ends at the IF. Its purpose: the first positioning, and the descent towards the runway.

Base turn, the teardropA specific outbound track, limited by timing or by a DME distance from a facility, then a turn to intercept the inbound track. The outbound and inbound tracks are not reciprocal.
Racetrack, like a holdingA holding-shaped pattern to lose height and get established inbound when a reversal procedure is not practical. It can be joined from any direction, with the same entries as a holding: direct, offset and parallel.
Procedure turn, the hockey stickA turn away from the outbound track (45°), then a turn the other way (180°), back onto the reciprocal: the inbound track. Its time and outbound track are on the approach chart.
DME arcA segment of a circle round a DME. Its radius is a DME distance, and points on the arc are often given by VOR radials.
Joining the racetrack: the holding entries
Direct entry, from sector 3Over the fix, the aircraft turns right and flies the pattern.
Offset entry, from sector 2Over the fix, it flies out on a track 30° off the outbound leg, into the holding side, for the outbound time. Then it turns right onto the inbound track, back to the fix.
Parallel entry, from sector 1Over the fix, it turns onto the outbound heading and flies out on the non-holding side, for the outbound time. Then it turns left, back across the holding side to the inbound track or the fix.

The entries, with the holding itself: NAV 009. The holding's times and turns: ACFT 004.

Intermediate, final and missed approach

After the initial approach, three more segments, each with its own job. The last is flown only if the aircraft cannot land.

All the segments in one profile: The approach segments, above. Where the MAPt lies on each kind of approach is there too.

Kinds of approach

LOC, VOR and NDB approaches

Three non-precision approaches, each named after the ground aid that guides it.

Localiser (LOC) approachLateral guidance from a localiser, the ILS's lateral part (NAV 005). Supported by DME or marker beacons, and sometimes by a VOR.
VOR approachThe aircraft intercepts a specific VOR radial and flies it in. Usually supported by a DME. Less accurate than a LOC/DME approach, so its OCA/H is higher.
NDB approachThe aircraft flies a specific track in relation to the NDB. It can be used with a DME.

The aids themselves: the VOR, the NDB and the DME, in NAV 005. The OCA/H: below.

RNP approaches and GLS

Approaches by satellite: the RNP approach, flown to one of four lines of minima, and GLS.

RNP approachEnabled by GNSS (NAV 006). It can give both lateral and vertical guidance.
RNP APCH, RNP approachThe navigation specification for RNP approaches.
RNP AR APCH, RNP authorization required approachAn RNP approach the operator needs a specific approval to fly. It is an APV.
The four lines of minima
GLS
GLS, GBAS landing systemNavigation by GNSS, with the support of GBAS (NAV 006). The GBAS standard reaches CAT III. Most GLS approaches in use today are CAT I.

LNAV and VNAV are also the FMS's two functions (NAV 007). On an RNP approach chart, LNAV and LNAV/VNAV name lines of minima.

Circling

When a straight-in landing does not fit, the instrument approach ends with a visual circle to the runway.

WhenThe approach does not meet the criteria for a straight-in approach.
CirclingThe visual phase of flight after an instrument approach, to bring the aircraft into position for landing on a runway.
Its nameA circling-only approach is named after its type and a letter, with no runway: VOR-A, for example.

The visual approach

An IFR flight may fly the last part of its approach by sight.

Visual approachAn approach by an IFR flight when part or all of an instrument approach procedure is not completed, and the approach is flown with visual reference to the terrain.
Who asksIf the weather permits, the pilot may request a visual approach.
The flight planAn aircraft on a visual approach is still on an IFR flight plan.
A visual approach chartAn aerodrome may publish one, with a visual route to follow.

A visual approach is not VFR. An IFR flight on a visual approach is still an IFR flight.

The visual approach at the end of a flight from A to B: NAV 004.

Minima and the chart

Obstacle clearance and the minima

How low an approach may go: the obstacle clearance the procedure designer works out, and the minimum the pilot flies to.

MOC, minimum obstacle clearanceThe least height the procedure keeps above the highest obstacle in each segment (NAV 008).
OCA/H, obstacle clearance altitude or heightThe lowest altitude (above mean sea level) or height (above the threshold or the aerodrome) at which the procedure still meets the obstacle clearance rules. Shown on the instrument approach chart, with the profile view.
Who works it outThe procedure designer, usually the ANSP. It is published on the approach chart.
DA/HDecision altitude or heightMDA/HMinimum descent altitude or height
Used onPA and APV onlyNPA only
What it isThe point where a missed approach must start if the pilot does not have the required visual reference: the runway, its lights or markings. Then the call is “negative”, and the aircraft goes around.The altitude or height below which the aircraft must not descend without the required visual reference.
Measured fromDA: mean sea level. DH: the threshold.MDA: mean sea level. MDH: the aerodrome elevation, or the threshold if it is more than 7 ft (2 m) below the aerodrome. For circling, the aerodrome elevation.
The two minimums a pilot flies to. An NPA flown as one continuous descent (CDFA, below) uses a DA/H too.

The operator's own minimum, DA/H or MDA/H, is never below the OCA/H.

Altitude from mean sea level, height from the aerodrome: ATM 005.

Type A, Type B and the categories

Instrument approach operations come in two types, set by how low the minimum is. The lowest type, Type B, comes in three categories.

Type AAn MDH or DH at or above 250 ft, flown on an NPA, an APV or a PA.
Type BA DH below 250 ft, on a PA only: CAT I, II or III.
CAT IA DH not lower than 200 ft, and either a visibility not less than 800 m or an RVR not less than 550 m.
CAT IIA DH below 200 ft but not below 100 ft, and an RVR not less than 300 m.
CAT IIIA DH below 100 ft or no DH, and an RVR below 300 m or no RVR limit.
All of it in one table

The DH and the RVR in different categories? The more demanding category applies: a DH of 200 ft, CAT I, with an RVR of 400 m, CAT II, is a CAT II operation.

CDFA, continuous descent final approachFlying the final approach of an NPA as one steady descent, with no level-off, from the FAF height down to about 50 ft over the threshold.

RVR, runway visual range: MET 007. Not the ILS's own facility performance category, which says how far down its guidance is good: NAV 005.

Reading an approach chart

An instrument approach chart puts one approach on one page: the heading, the plan view from above, the profile from the side, and the minima. This one is made up, laid out as a real one.

  1. MinimaThe box at the foot: the OCA (H) for each approach category, A to D (ACFT 001), for the ILS and for the LOC alone. ILS, category A: 320 (200), an altitude of 320 ft and a height of 200 ft.
  2. Final approach trackAlong the localiser's feather, in magnetic: 267°. The aircraft flies it in to runway 27.
  3. Inbound trackThe racetrack's inbound leg at FB: 267°, towards the fix. Its outbound leg: 087°.
  4. VOR and DMEFBY, a VOR/DME at the aerodrome. Its box gives its letters, its frequency (114.6 MHz) and its letters in Morse.
  5. NDBFB, a locator: a low-powered NDB, 5.7 NM out on the final approach track. Its box: its letters, its frequency (375 kHz) and its letters in Morse.
  6. MSAThe box at the upper left: 2 500 ft within 15 NM, 3 200 ft out to 25 NM, round the aerodrome reference point (ARP).
  7. VariationVAR 4°E 2020: magnetic north lies 4° east of true north, as measured in 2020 (NAV 001).
  8. ProfileFrom the side: level at 2 000 ft to FB, the FAP, then down the 3° glide path. The MAPt, and the missed approach climbing away.

An instrument approach chart, not an aerodrome chart. An aerodrome chart shows the aerodrome on the ground: its runways, taxiways and aprons.

The waypoints and the other chart symbols: NAV 002. The ILS: NAV 005.

Learn by heart

Learn the approach

Every term and figure on this page: name it, then say what it is.

The arrival

In test mode the answers are hidden. Click or tap a card to reveal it.

The instrument approach

In test mode the answers are hidden. Click or tap a card to reveal it.

Kinds of approach

In test mode the answers are hidden. Click or tap a card to reveal it.

Minima

In test mode the answers are hidden. Click or tap a card to reveal it.

Reading material